Real failures often start when a seal is selected for oil retention but not for external mud, abrasive dust and repeated splash cycles. This integrated COMBI seal concept combines contaminant exclusion and lubricant retention in one compact solution to help protect shafts, bearings and grease in severe service.
Product type: integrated rotary sealing solution
Seal family: COMBI seal
Primary function: contaminant exclusion and lubricant retention
Main pain point: premature seal failure in mixed mud and dust
Contaminant focus: wet mud, dry dust and abrasive debris
Mud resistance: designed for splash and packed-mud exposure
Dust resistance: designed to reduce fine-particle ingress
Mixed contamination defense: suitable for alternating wet and dry exposure
Lubricant retention: helps keep grease inside the bearing zone
Bearing protection: reduces contaminant paths toward bearings
Shaft protection: helps limit abrasive contact at the shaft surface
Abrasion control: intended for harsh particulate environments
Lip protection: integrated geometry shields the primary sealing area
Debris exclusion: helps block coarse external contamination
Splash resistance: supports muddy wash and wheel-end exposure
Fine particle exclusion: targets dust-driven wear
Wear control: reduces contamination-related wear mechanisms
Service-life objective: longer, more predictable seal intervals
Downtime objective: fewer unplanned stoppages
Maintenance objective: simplify seal-related service planning
Spare-part objective: reduce repeated replacement demand
Retrofit use: application-dependent replacement or upgrade
Equipment type: rotating shafts, hubs, axles and bearing positions
Industries: construction, agriculture and industrial equipment
Operating environment: muddy, dusty and abrasive outdoor service
Duty cycle: intermittent or continuous severe-duty operation
Installation position: shaft-to-housing sealing location
Rotating use: intended for rotary applications
Alignment: correct concentricity is required
Housing interface: matched to bore and retention method
Sealing mechanism: integrated exclusion plus retention functions
Design concept: all-in-one COMBI configuration
Material selection: elastomer and reinforcement selected by application
Temperature selection: verify actual operating range
Speed selection: verify shaft speed and lip surface speed
Pressure selection: confirm pressure conditions before use
Size selection: match shaft diameter, housing bore and seal width
Surface requirement: suitable shaft finish supports sealing life
Inspection: check lip, shaft track, corrosion and housing damage
Maintenance: remove packed mud before inspection or replacement
Replacement trigger: leakage, hardening, lip damage or excessive wear
Storage: keep clean, dry and protected from deformation before installation
Specify the seal from real operating data rather than nominal dimensions alone. Matching contamination level, speed, temperature, shaft finish and installation conditions is essential to solving the actual failure mode.
.png){kind=logo}
